When you open Putty make sure that you are connecting by using Serial port and correct COM port with correct speed ( Please find the attached document) If it is COM4 then take the COM 4 properties and set the baud rate (Please find my attachment for setting baud rate as 115,200 with N-8-1 ) Click OK to save the settings and make sure that the settings are saved If you are not sure about the port name just remove the USB cable connected to the NetApp so that you can see which COM port is disappearing from device mgr. Open Dev Manager in your laptop and go to – Ports (COM &LPT) USB Serial Device (COM4) – In My case it was COM4, it may be different like COM3 or COM2 etc. ( If you are not sure abt the port please find the below link) You can connect one end to your Laptop USB port and other end to the net app Micro USB Serial console port. Make sure you are using the correct cable which comes with NetApp. (I am not sure is there any other way to power recycle at this point)
Once you set the shelfs ID for all the shelfs use the power button for power recycle. Remove the front plastic cap on Shelf 2 (expansion unit) then keep pressing the small button to change the shelf id and set ID to 10 We need to assign the correct shelf ID for Shelf 2 Once you power on all the shelfs, Netapp will automatically assign the Shelf id 00 to the first shelf (shelf which has node1 and node2). Power on all the NetApp nodes by using power button located near by the power connection port The document comes with NetApp is for the person who already have experience in Netapp or Linux. I cannot even get into this box let alone set an IP> Nothing is intuitive.Ĭan someone point me to so usefull documentation about this? My search has returned nothing.nothing on Youtube.numerous doc show up in google search pointing to netapp/library locations that never load.NetApps own Setup video expects all this side to be done already and logged into the Cluster Management IP.so that video is completly irelevant. Seriously.I am NOT a NetApp Guru.this is the first one I am setting up. The it says to complete the config using data collected.so. Power on the system.(turn the power buttons on again?) Set shelf ID.HOW? What, where are the command to do this?Ĭycle Power to disk shelves.HOW? more commands that are no where to be found. So once I get that working.where are detailed setup instructions?
I hook up the Micro USB on laptop, Win7, its missing a device driver (MCP2221 USB-I2C/UART Combo)
0 kommentar(er)
